Teldat bintec W1002n Manuale Utente Scaricare il pdf (Pagina 247)

100

101

Field Description

Interface Select the interface for which NAT is to be configured.

Possible values:

• ", (default value): NAT is configured for all interfaces.

• >6 ?: Select one of the interfaces from the

list.

Type of traffic

Select the type of data traffic for which NAT is to be configured.

Possible values:

•  @7 2"/A (default value): The data

traffic that comes from outside.

•  @ 2"/A: Outgoing data traffic.

• : @  2"/A: Data traffic excluded from

NAT.

NAT method

Only for Type of traffic =  @ 2"/A

Select the NAT method for outgoing data traffic. The starting

point for choosing the NAT method is a NAT scenario in which

an "internal" source host has initiated an IP connection to an "ex-

ternal" destination host over the NAT interface, and in which an

internally valid source address and internally valid source port

are translated to an externally valid source address and an ex-

ternally valid source port.

Possible values:

• # (UDP only): Any given external host may send IP

packets via the external address and the external port to the

initiating source address and the initial source port.

• # (UDP only): Like full-cone NAT; as ex-

ternal host, however, only the initial "external" destination host

is allowed.

• %## (UDP only): Like restricted-cone

NAT; however, exclusively data from the initial destination

port are allowed.

• , (default value) any protocol: Outbound, an ex-

ternally valid source address and an externally valid source

port are administratively set. Inbound, only response packets

Teldat GmbH

12 Networking

bintec WLAN and Industrial WLAN 233

1 2 ... 242 243 244 245 246 247 248 249 250 251 252 ... 553 554

Commenti su questo manuale

Nessun commento

Teldat bintec W1002n Manuale Utente Pagina 247

Commenti su questo manuale